Philips CDC 936 - Programming; Storing a Programme; Checking the Programme; Erasing a Programme

English
<@) PROGRAMMING
STORING A PROGRAMME (PRG)
- By programming the chang
- FULL lights up if you exce«
- li.lRONG DISC lights up if y
- USE 0-3 lights up if you p
• In STOP mode, press PRG
- SELECT DISC lights up a
• Select the number of the fi
• Key in the required track nt
- Every track number you en'
- The display always shows t
er you can play up to 30 tracks in any required sequence.
3d the maximum of 30 tracks,
ou select a nonexistent CD number,
ress or while programming.
(programme) 3 to open the memory,
nd BBS! starts flashing.
rst required CD using DISC SELECT 70 or DISC 6 (on the remote control).
mbers of the selected CD using the 1-0 digit buttons 2.
ter in this way will be included immediately in the programme.
:he number of tracks and the playing time of your programme.
is'HI sl
• If you wish to store tracks from another CD, you should first enter the number of the CD.
• Press PRG to quit the PROGRAM mode.
• Press PLAY/REPLAY 78 to play the program.
CHECKING THE PROGRAMME IREVIEW) _
• Press REVIEW 73 prior to, during or after programmed play.
- REVIEW lights up and all CD and track numbers appear in
the programmed sequence on the display.
- Under TRACK TIME you will see the playing time of each
track.
NO FROGRRN will light up if no track numbers have yet been
stored.
With REVIEW you can proceed more rapidly to the next block
of information.
PLAYING THE PROGRAMME (PLAY/REPLAY) _
• Press PLAY/REPLAY 73.
- Playback starts with the first number of the programme.
The EDIT 74, PRG 3 and CLR 4 and PEAK SEARCH 23 buttons
cannot be used during programmed play.
Searching for a particular passage is only possible within the
track being played.
ERASING A PROGRAMME (STOP/CP, CLR or OPEN/CLOSE)
In PLAY mode:
• Press OPEN/CLOSE 77 or STOP/CP 17 (twice).
In STOP mode:
• Press OPEN/CLOSE 77, CLR 4 or STOP/CP 77
“ The programme has now been erased.
ERASING A TRACK FROM A PROGRAMME (CLR)
• Press REVIEW 73 before or after programmed play (STOP
mode).
- All CD and track numbers appear in the programmed
sequence on the display.
• Press CLR (clear) 4 as soon as the number you wish to erase
appears.
- The number has now been erased.
“ The display shows the remaining number of tracks and the
remaining programme time for a few seconds.
NO PROuRflN will light up if no track numbers have yet been
stored.
14