20 EN
Select a radio range
1 Tap [Radio Range].
2 Tap [Distance] or [Local] to select a tuner
sensitivity.
• [Distance]: Stations with strong and
weak signals can be tuned to.
• [Local]: Only stations with strong
signals can be tuned to.
Enable the RDS feature
Note
• RDS feature is enabled by default.
• Only after the RDS feature is enabled, the option of
[PTY list] is displayed.
Tap [RDS On] to enable the RDS feature.
» The option of [PTY list] is displayed.
• To disable the RDS feature, tap [RDS
Off].
Tune to a radio station
1 Tap FM or AM to select a band.
• FM bands: FM1, FM2, FM3
• AM bands: AM1, AM2
2 Tap or repeatedly until the frequency
of target radio station is displayed.
• To tune to a radio station automatically,
tap and hold or until the
frequency digits start change.
Tip
• You can also press BAND on the remote control
repeatedly to select a band.
Store radio stations in
memory
You can store up to 6 stations in each band.
Store radio stations manually
1 Select a band.
2 Tune to the target radio station.
3 Tap and hold one of the channels (1 to 6)
over two seconds.
» The radio station is saved under the
selected channel.
Store radio stations automatically
You can search for a radio station with intro
search, which broadcasts a 10-second preview
of each detected radio station.
1 Select a band.
2 Tap .
3 Tap [Auto Store].
» Auto search starts. The six strongest
stations of the selected band are saved
in preset channels automatically.
To Next Page
Loading...
