Philips D Series - Network Connectivity and IR Pass-through; Setting up IR Pass-through Connection; Wire-connecting to Network and Settings

65BDL4550D_75BDL4550D_86BDL4550D
17
3.5. IR Pass-through Connection
DVD / VCR / VCD
(DVD / VCR / VCD)
Remote Control
FORMAT
SOURCE
INFOLIST
OPTIONSADJUST
VOL
NORMAL
ID
ID SET ENTER
[IR OUT]
[IR IN]
3.6. Wire-connecting to Network
PC
[RJ-45]
[RJ-45]
ROUTER
INTERNET
Network Settings:
1. Switch the router on and enable its DHCP setting.
2. Connect the router to this display with an Ethernet cable.
3. Press [ ] HOME button on the remote control, then select
Setup
.
4. Select
Connect to network
, then press [ ] button.
5. Wait until this display nds the network connection.
6. If the “End User License Agreement” window prompts, accept the agreement.
NOTE: Connecting with a shielded CAT-5 Ethernet cable to comply with the EMC directive.