Philips D260 - Select the Recall Duration; Dial Mode; Auto Clock

30 EN
Note

To enter a pause, press and hold .
 ,IWKHSUHÀ[QXPEHULVVHWDQGWKHGHWHFWQXPEHULVOHIW
HPSW\WKHSUHÀ[QXPEHULVDGGHGWRDOORXWJRLQJFDOOV
 The feature is unavailable if the dialed number starts
with * and #.
Select the recall duration
Make sure that the recall time is set correctly
before you can answer a second call. In normal
case, the phone is already preset for the recall
GXUDWLRQ<RXFDQVHOHFWDPRQJRSWLRQV
[Short], [Medium] and [Long]. The number of
available options varies with different countries.
For details, consult your service provider.
1 3UHVVMENU/OK.
2 Select [Services] > [Recall time], then
press MENU/OKWRFRQÀUP
3 Select an option, then press MENU/OK to
FRQÀUP
» 7KHVHWWLQJLVVDYHG
Dial mode
Note

This feature only applies to models that support both
tone and pulse dial.
'LDOPRGHLVWKHWHOHSKRQHVLJQDOXVHGLQ\RXU
FRXQWU\7KHSKRQHVXSSRUWVWRQH'70)DQG
SXOVHURWDU\GLDO&RQVXOWWKHVHUYLFHSURYLGHU
for detailed information.
Set the dial mode
1 3UHVVMENU/OK.
2 Select [Services] > [Dial mode], then
press MENU/OKWRFRQÀUP
3 Select a dial mode, then press MENU/OK
WRFRQÀUP
» 7KHVHWWLQJLVVDYHG
Note

If your phone is in pulse dial mode, press GXULQJD
FDOOIRUWHPSRUDU\WRQHPRGH'LJLWVHQWHUHGIRUWKLV
FDOODUHWKHQVHQWRXWDVWRQHVLJQDOV
Auto clock
Note

This service is network dependent.
 Make sure you have subscribed to the caller ID service
before you use this feature.
,WV\QFKURQL]HVWKHGDWHDQGWLPHRQ\RXU
phone with the public switched telephone
QHWZRUN3671DXWRPDWLFDOO\)RUWKHGDWHWR
EHV\QFKURQL]HGPDNHVXUHWKHFXUUHQW\HDULV
set.
1 3UHVVMENU/OK.
2 Select [Services] > [Auto clock], then
press MENU/OKWRFRQÀUP
3 Select [On]/[Off]3UHVVMENU/OK.
» 7KHVHWWLQJLVVDYHG
Register additional handsets
<RXFDQUHJLVWHUDGGLWLRQDOKDQGVHWVWRWKHEDVH
VWDWLRQ7KHEDVHVWDWLRQFDQUHJLVWHUXSWR
handsets.
1 3UHVVMENU/OK on the handset.
2 Select [Services] > [Register], then press
MENU/OKWRFRQÀUP
3 3UHVVDQGKROG on the base station for
5 seconds.
4 (QWHUWKHV\VWHP3,13UHVVREDIAL/C to
make corrections. Then press MENU/OK
WRFRQÀUPWKH3,1