Philips DCM2060/79 - Listen to FM Radio; Auto Install FM Radio Stations; Tune to FM Radio Stations; Program FM Radio Stations Automatically

13EN
5 Listen to FM
radio
Auto install FM radio stations
When the unit turns to FM tuner mode, and no
radio stations are stored, the unit prompts you
to search and store all the available FM stations.
Note
•
Position the antenna as far as possible from TV, VCR, or
other radiation source.
• Ensure that you have connected and fully extended the
supplied FM antenna.
1 Press FM to select FM tuner mode.
» [AUTO INSTALL - PRESS PLAY, STOP
CANCEL] (to auto install, press
;
to cancel, press
)isdisplayed.
2 Press and hold for 3 seconds to start
full scan.
» The unit automatically stores FM radio
stationswithsufcientsignalstrength
andthenbroadcaststherstpreset
station.
Tip
•
To exit storing mode, press or .
• RDS function is not available.
Tune to FM radio stations
1
In FM tuner mode, press and hold /
for 3 seconds.
» [SEARCH] (search)isdisplayed.
» The unit tunes to an FM station with
strong reception automatically.
2 Repeat step 1 to tune to more stations.
To tune to a station with weak signal
Press
/ repeatedlyuntilyoundoptimal
reception.
Program FM radio stations
automatically
Note
•
You can program a maximum of 20 preset FM radio
stations.
In FM tuner mode, press and hold PROG for 3
seconds.
» [AUTO] (auto)isdisplayed.
» The unit stores all the FM radio stations
automaticallyandthenbroadcaststherst
preset radio station.
Program FM radio stations
manually
1
In tuner mode, tune to an FM radio station.
2 Press PROG to activate programming
mode.
» [PROG] (program)blinks.
3 Press / repeatedly to select a channel
number.
4 Press PROGagaintoconrm.
5 Repeat steps 1-4 to store other FM
stations.
Note
•
To remove a pre-stored station, store another station
in its place.
DCM2060_79_UM_V1.0.indd 13 6/1/2012 10:53:57 AM