Philips DCM2060 - Set Clock; Turn on

11
English
Turn on
Press .
» The unit switches to the last selected
source.
Note
• To select a source, press SOURCE repeatedly or the
source selection buttons on the remote control.
Switch to standby mode
Press again to switch the unit to standby
mode.
» Theclock(ifset)appearsonthedisplay
panel.
2 Press and hold for 3 seconds to start
full scan.
» The unit automatically stores FM radio
stationswithsufcientsignalstrength
andthenbroadcaststherstpreset
station.
Tip
• To exit storing mode, press or .
Set clock
1 In standby mode, press and hold CLOCK
SET on the remote control for two
seconds.
» [SET CLOCK] (setclock)scrollson
the display.
2 Press CLOCK SET again.
» The 12/24 hour format blinks.
3 Press / repeatedly to select hour
format.
4 Press CLOCK SETtoconrm.
» The hour digits blink.
5 Repeat steps 3-4 to set the hour.
6 Repeat steps 3-4 to set the minute.
7 Repeat steps 3-4 to select whether to
synchronize time of this unit with RDS
stations.
• [RDS TIME SYNC [N] ]: time
synchronization is deactivated.
• [RDS TIME SYNC [Y] ]: the unit
synchronizes time from the RDS
stations automatically.
Note
• The accuracy of the transmitted time depends on the
RDS station that transmits the time signal.
• If no button is pressed in 90 seconds, the unit exits
clock setting mode automatically.
EN
DCM2060_12_UM_Book1_V3.0.indb 11 11/15/2013 2:59:32 PM