Philips DCM2060 - Select Stereo;Mono Broadcast; 6 Other Features; Set the Alarm Timer

16
6 Other features
Set the alarm timer
This unit can be used as an alarm timer. You can
select CD, FM tuner, iPod/iPhone/iPad, or USB
as alarm source.
Note
• Make sure that you have set the clock correctly.
1 In standby mode, press and hold TIMER
until [SET TIMER](settimer)scrollsonthe
display.
» [SELECT SOURCE](selectsource)is
displayed.
2 Press SOURCE repeatedly or the source
selection buttons on the remote control to
select a source: disc, FM tuner, iPod/iPhone/
iPad, or USB.
3 Press TIMERtoconrm.
» The hour digits blink.
4 Press / repeatedly to set the hour.
5 Press TIMERtoconrm.
» The minute digits blink.
6 Repeat steps 4-5 to set the minute.
Note
• If no button is pressed in 90 seconds, the unit exits
alarm setting mode automatically.
• If iPod/iPhone/iPad is selected as alarm source, and you
have created a playlist called “PHILIPS” in iTunes and
import it to your iPod/iPhone/iPad, you will wake to a
random track in the playlist.
• If no “PHILIPS” playlist is created in the iPod/iPhone/
iPad or no track is stored in the playlist, you will wake
to your last listened track in the iPod/iPhone/iPad.
Select stereo/mono broadcast
Note
• Stereo broadcast is the default setting for tuner mode.
• For stations with weak signals: to improve the reception,
change to monaural sound.
In FM tuner mode, press OK to switch between
mono and stereo broadcast.
EN
DCM2060_12_UM_Book1_V3.0.indb 16 11/15/2013 2:59:38 PM