10 EN
Demonstrate the features
1
After connecting the power, the micro
music system starts to demonstrate
features automatically.
2 In the standby mode, you also can
demonstrate features by pressing
until
"DEMO ON" is displayed.
» The features are displayed one by one
across the display panel.
To turn off the demonstration, press
again.
Prepare the remote control
Caution
Risk of explosion! Keep batteries away from heat,
Risk of decreased battery life! Never mix different
brands or types of batteries.
Risk of product damage! When the remote control is
not used for long periods, remove the batteries.
To insert the remote control battery:
1 Open the battery compartment.
2
3 Close the battery compartment.
a
b
c
Set clock
1
In standby mode, press and hold CLOCK/
DISPLAY on the remote control to
activate the clock setting mode.
» The hour digits are displayed and begin
to blink.
2 Press / to set the hour, and press
CLOCK/DISPLAY.
» The minute digits are displayed and
begin to blink.
3 Repeat step 2 to set the minute.
Turn on
Press .
» The unit switches to the last selected
source.
Switch to standby
Press again to switch the unit to standby
mode.
»
display panel.
Switch to ECO standby mode:
Press and hold
for more than 3 seconds.
»
displayed for 3 seconds and then
disappeared.
Tip
The unit switches to Eco Power Standby mode after 15
minutes in standby mode.
Switch between standby mode and ECO
standby mode:
Press and hold
for more than 2 seconds.
To Next Page
Loading...
