EasyManua.ls Logo

Philips DCM3065 - 6 Shflàfdwlrqv; Set the Sleep Timer; Play from an External Device; Headphone

Philips DCM3065
19 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
17
English
EN
Set the sleep timer
This unit can switch to standby automatically
after a set period of time.
 When the unit is turned on, press 
 repeatedly to select a set period of
time (in minutes).
» When sleep timer is activated,
is
displayed.

 Press  repeatedly until [OFF]
(off) is displayed.
» When sleep timer is deactivated,
disappears on the display.
Play from an external device
You can also listen to an external audio device
through this unit.
 Press MP3 LINK to select the MP3 link
source.
 Connect the supplied MP3 link cable to:
 the MP3 LINK connector (3.5mm) on
the unit.
 the headphone connector on an
external device.
3 Start to play the device (see the device's
user manual).
Headphone
Plug headphones (not supplied) into the
connector on the unit to listen through the
headphones.
9 Product
information
Note
Product information is subject to change without prior
notice.


Maximum Output Power 58W RMS
 60 Hz - 16 kHz,
±3 dB
Signal to Noise Ratio >65dBA
MP3 link input 500mv, 20kohm

Tuning Range FM: 87.5 - 108 MHz
Tuning grid 50 KHz
FM sensitivity
- Mono
26 dB
Total Harmonic
Distortion
<2%
Signal to Noise Ratio >55 dB
Number of presets 20 (FM)
Speakers
Speaker Impedance 8 ohm
Speaker Driver 2 X 2.5" full range
Sensitivity >82 dB/m/W
DCM3065_51_UM_V1.0.indb 17 3/2/2012 2:08:14 PM

Related product manuals