Philips DTB3185 - Get started; Initial Setup and Connections

9
English
EN
3 Get started
Caution
• Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
rear of the apparatus. Write the numbers here:
Model No. __________________________
Serial No. ___________________________
Connect the FM/DAB antenna
Tip
• Make sure that you have connected and fully extended
the antenna before your connect the power supply.
• For better reception, connect an outdoor FM antenna
to the FM/DAB ANTENNA socket.
• The unit does not support MW radio reception.
• Connect the supplied FM/DAB wire
antenna to the FM/DAB ANTENNA
socket.
Connect power
Caution
• Risk of product damage! Make sure that the power
voltage corresponds to the voltage printed on the back
or underside of the unit.
• Risk of electric shock! When you unplug the AC power
cord, always pull the plug from the socket. Never pull
the cord.
• Before connecting the AC power cord, ensure you have
completed all other connections.
• Connect the power cord to:
• the AC ~ MAINS socket on the main
unit.
• the wall outlet.
Prepare the remote control
Caution
• Risk of explosion! Keep batteries away from heat,
sunshineorre.Neverdiscardbatteriesinre.
To insert the remote control battery:
1 Open the battery compartment.
2 Insert 1 AAA battery with correct polarity
(+/-) as indicated.