Philips DTB3185 - Basic Unit Configuration

10 EN
3 Close the battery compartment.
Note
• If you are not going to use the remote control for a
long time, remove the battery.
• Batteries contain chemical substances, so they should
be disposed of properly.
Set clock
Note
• You can set the clock in standby mode only.
1 In standby mode, press and hold CLOCK
to activate the clock setting mode.
2 Press PRESET/ALBUM / to select 12
hour or 24 hour format.
3 Press CLOCKtoconrm.
» The hour digits begin to blink.
4 Press PRESET/ALBUM / to set the
hour.
5 Press CLOCKtoconrm.
» The minute digits begin to blink.
6 Press PRESET/ALBUM / to set the
minute.
7 Press CLOCKtoconrm.
Note
• You can also press VOL -/+ on remote control or main
unit to set hour format/hour/minute.
• To exit clock setting mode without storing, press
/MENU.
• If no button is pressed in 90 seconds, the system exits
clock setting mode automatically.
Tip
• You can press CLOCK to view the clock in any source
mode.
Store radio stations
automatically
If no radio stations are stored, the unit can store
radio stations automatically.
1 Turn on the unit.
2 Press CD/FM/DAB+ repeatedly to select
the FM tuner source.
» [AUTO INSTALL -- PRESS PLAY --
STOP CANCEL] (press to start
automatic installation, or press to
cancel) is displayed.
3 Press .
» The unit automatically stores FM radio
stationswithsufcientsignalstrength.
» After all available radio stations are
stored,therststoredradiostationis
broadcast automatically.