Reference : SGP_AVS_SW_ATLAS-05-05 Classification : COMPANY RESTRICTED
Version : 0.17 Project : ATLAS_DSW
Status : Proposed Chapter : User Manual
Date : 2006-09-12
Section : Diagnostic Software (Leco+)
© Philips Electronics N.V. 2006 Philips Semiconductors Page 119 of 124
APPENDIX A TERMINAL INTERFACE 1
2
The DVD+RW set needs to be connected to a terminal in order to see the message when 3
starting the set e.g.: 4
Factory Diagnostics and Service Software 5
DVD Video Recorder (Dec 13 2003, 10:55:37) 6
7
Version :258 Build :20031213_1030 8
Release :P1_7_b Buildtype :no 9
Baseline :I_P1_8_63 Variant :verum:dvdrw2_lib 10
11
DS:> 12
13
A.1 SOFTWARE SETTINGS: 14
The terminal needs to be set to 19200 Baud, 8 Data bits, no Parity, 1 Stop bit, no Flow control, 15
and no XON/XOFF usage. 16
17
A.2 HARDWARE CONNECTION: 18
Pin-out of the ‘Service’ connector on the board: 19
20
1 - Txd 21
2 - PIO ‘Service’ Pin 22
3 - Rxd 23
4 - RTS 24
5 - Gnd 25
6 - CTS 26
7 - +5V 27
28
The ‘Service’ connector provided to you will connect pin 2 to pin 5, in order to have the software 29
detect that service mode is requested. 30
31
32
33
To Next Page
Loading...
