Reference : SGP_AVS_SW_ATLAS-05-05 Classification : COMPANY RESTRICTED
Version : 0.17 Project : ATLAS_DSW
Status : Proposed Chapter : User Manual
Date : 2006-09-12
Section : Diagnostic Software (Leco+)
© Philips Electronics N.V. 2006 Philips Semiconductors Page 6 of 124
INT : Interrupt
1
LED : Light Emitting Diode 2
NVRAM : Non Volatile Random Access Memory 3
OPC : Optimal Power Control 4
PIO : Peripheral IO pin 5
PSCAN : Progressive Scan 6
RC : Remote Control 7
S2B : Serial to Basic Engine 8
SYS : System 9
TOC : Table Of Contents 10
UART : Universal Asynchronous Receiver Transmitter 11
UDF : Universal Disc Format 12
VIP : Video Input Processor 13
VMIX : Video Matrix (Video switching) 14
1.3 PURPOSE, SCOPE AND SHORT DESCRIPTION 15
This document is the user manual for the Diagnostic Software (DSW). 16
Its goal is to facilitate the usage of the DSW software. 17
18
The users of this document are typically the factory and service teams. 19
20
The Diagnostic Software consists of independent ‘atomic’ tests, called nuclei. 21
Each nucleus forms a test to indicate possible hardware failure. 22
Its purpose is to facilitate fault-finding in DVD+RW sets. 23
24
This document describes all tests that are currently available in the diagnostic software. 25
26
Different DVD+RW recorder sets containing different hardware become available all the time, 27
resulting in hardware diversity covered by chapter 118:‘Digital Board Diversity’. 28
29
Apart from this there will be some different software-builds that define some hardware-specific 30
issues at compile-time. 31
As a result of this there will be parts in this document that will NOT be executable on your 32
specific DVD+RW recorder. 33
So if you execute a nucleus from one of these groups not currently in your software-build the 34
command-line will e.g. look like: 35
DS:> 1800 36
DS:> 37
38
This user manual is intended for an audience that is aware of the diversity in hardware and is 39
aware which hardware is encompassed in their DVD+RW recorder sets. 40
41
Please note that the examples given in this user manual can differ from your actual hardware. 42
The error codes returned by the diagnostic software will ALWAYS be as indicated in the 43
nucleus-description. Should there be any discrepancy then please contact our team so we can 44
correct the issue. 45
46
1.4 NOTES 47
The implementation of DS_ASP_GlinkRcLoop is still unclear because no information about the 48
IR blaster IP block of the LeCo+ codec is available. 49
To Next Page
Loading...
