1. Mechanical Instructions
Note: The position numbers given here refers to the Exploded view on chapter 8.
1.1. Dismantling of the DVD Tray cover manually
1) Insert a screwdriver into the slot provided at the bottom of the set and push in the direction as shown in
Figure1 to unlock before sliding the Tray cover 110 out.
Figure 1 Unlock the tray loader
2) Remove the Tray cover 110 as shown in Figure 2.
Figure 2 Remove the tray cover
1.2. Dismantling of the Front Panel
1) Remove 7 screws to loosen Top cover 240.
2) Remove screws to loosen the Plate Front Loader 183 and detach the Front Assembly 0901 as shown in
Figure 3. The Front Panel Service Position is shown in Figure 4.
To Next Page
Loading...
