Reference : SGP_AVS_SW_ATLAS-05-05 Classification : COMPANY RESTRICTED
Version : 0.17 Project : ATLAS_DSW
Status : Proposed Chapter : User Manual
Date : 2006-09-12
Section : Diagnostic Software (Leco+)
© Philips Electronics N.V. 2006 Philips Semiconductors Page 9 of 124
15 HDMI
16 Analogue Slave Processor
20 Front End
21 Hard Disk
22 DTTM
23 USB
1
2.2 ERROR HANDLING 2
Results returned from a diagnostic nucleus to the control/service PC are terminated by a 'CR' 3
character (included in the string length). 4
5
The result has the following layout 6
<number> <string> [Test OK | Error] @<CR> 7
8
The use of the “@” enables the Asterix system on the control PC to parse the output string of 9
each nucleus into a database. This system is used in the factory and automates the test 10
sequences needed to test each product using the Diagnostic and Service Software. 11
12
<number> is a 6-digit decimal number padded with leading zeros if its value is less than 6 13
digits. The first four digits identify the generating nucleus (group and nucleus); the latter two 14
digits indicate the error number. 15
16
Figure 2 Error-code of a diagnostic nucleus. 17
18
To Next Page
Loading...
