Reference : SGP_AVS_SW_ATLAS-05-05 Classification : COMPANY RESTRICTED
Version : 0.17 Project : ATLAS_DSW
Status : Proposed Chapter : User Manual
Date : 2006-09-12
Section : Diagnostic Software (Leco+)
© Philips Electronics N.V. 2006 Philips Semiconductors Page 47 of 124
1
Nucleus Name
DS_BE_RegionCodeGet
Nucleus Number 929
Description Read the region code from the AV3.
Technical - Send the ATAPI REPORT_KEY command
Execution Time
User Input None
Error Number Description
92900 The command executed successfully
92901 There was a time-out while communicating
92902 The Basic Engine returned an unexpected result
92903 The BE returned an error code
92904 No acknowledge received from BE
92905 Communicating with the Basic Engine failed
92906 This nucleus is not supported by the engine
Example
DS:> 929
092900: DVD region 1
Test OK @
2
Nucleus Name
DS_BE_RegionCounterReset
Nucleus Number 930
Description Reset the region counter in the AV3.
Technical - Send a special ATAPI RESET_REGION_COUNTER command
Execution Time
User Input None
Error Number Description
93000 The command executed successfully
93001 There was a time-out while communicating
93002 The Basic Engine returned an unexpected result
93003 The BE returned an error code
93004 No acknowledge received from BE
93005 Communicating with the Basic Engine failed
93006 This nucleus is not supported by the engine
Example
DS:> 930
093000:
Test OK @
3
Nucleus Name
DS_BE_AdjustLaserControl
Nucleus Number 931
Description Adjust the DVD-M (with the OPU) with PCBA. (So adjusts the two PCBS to
each other)
Technical - Sending a transparent BIT engine command to align the PCBs to each
other.
Important note: This nucleus uses the transparent bit engine interface of the drive. It is
not guaranteed to work on all drives. Only use this nucleus if you are sure
that the drive supports this interface
Execution Time 30 seconds
User Input None
Error Number Description
93100 The command executed successfully
93101 There was a time-out while communicating
93102 The Basic Engine returned an unexpected result
93103 The BE returned an error code
93104 No acknowledge received from BE
93105 Communicating with the Basic Engine failed
93106 Unable to enter service mode
93107 This nucleus is not supported by the engine
Example
DS:> 931
093100:
Test OK @
To Next Page
Loading...
