8
9
When the channel search is completed, 'Auto ch. search
complete' will appear on the TV screen.
Press SYSTEM-MENU repeatedly to remove all the menus
from the screen
x Very few TV channels were found
¢_ During 'Automatic channel search _ the DVD Recorder detects
whether an antenna or a cable TV signal is connected. If you have
connected a cable TV signal but found very few TV channels, you
must search the channels manually,
To do so, select 'Cable/Antenna' instead of line 'Auto Ch.
Programming' in step 6 and confirm with I_ .
If you select 'Cable', channels 1-125 will be available,
If you select 'Anten.', channels 2-69 will be available.
Select your type of connection by pressing Im repeatedly:
'Antell.', 'Cable' or 'Auto: automatical{y detects which one you
have.
Confirm the setting with OK.
Press SYSTEM-MENUto go to the next menu. Press OKto
start channel search as prompted by the on-screen message. When
the channel search is complete, press SYSTEM-MENU repeatedly Problem
to remove all the menus.
Installation
Auto Ch.Programming
Searching forTV channels
000Channels found
Please wait
You can read about how to search for a TV channel manually in the following section 'Adding
and deleting TV channels manually'.
26 Installing your DVD Recorder
To Next Page
Loading...
