Philips DVDR80 - Manually setting the time & date

Manually setting the time & date
If the time is incorrect, this could be due to a weak or disrupted TV signal If this is the case,
switch off the automatic function
Attention!
If data from the GUIDE PLus+ ® system were loaded, you can not change the clock/date because
this information was taken from the GUIDE Plus+ ® system Therefore you can not select this
function.
3
4
Press SYSTEM-MENU on the remote control. The menu bar
will appear
Select 'T_' using • or • .
Select line 'Installation' using CH-• or •CH+ and confirm
with •
Select line 'Time/Date' using CH-• or •CH+and confirm
with •.
5
6
7
8
9
10
11
If the setting
Ix=
Not allowerf will appear on the TV screen
¢_ The time/date will automatically be taken from the EPG information.
Therefore you can not set the time/date manually.
Select 'Manual with CH- • or • CH+.
Confirm with OK.
Change the time in line 'Time' using the number buttons 0..9 on
your remote control
Check 'AM/P_t, 'Yeak, 'Month', and 'Date' in the same way
To select between the fields, use CH- • or • CH+.
Change the information with • , • or the number buttons
0..9.
Select one of the following settings in line 'Daylight Saving':
'On': The time set corresponds to the summer time (summer
time is on)
'Off: The time set corresponds to the winter time (summer time
is off)
When all settings are correct, confirm with OK.
To end, press SYSTEM-MENU
has been confirmed with OK the automatic system is disabled.
Problem
1
Time/Date
Manual
Time 09:02
AM/PM AM
Year 2003
Month 01
Date 01
Daylight Saving Off
To exit press
SYSTEMMENU
32 Installing your DVD Recorder