ErgoLine D330/D340
Customer Engineer Manual
Page 2-37
Q0 Not used
Q1 Not used
Q2 Not used
R Not used
Sr? Returns decimal value of register r
Sr=xxx Program register r with xxx. Returns OK if x
does not exceed the maximum value for r,
otherwise ERROR is returned.
T Not used
V0 Numeric indication of result codes
V1 Verbose indication of result codes
X0 Suppress all result codes
X1 Suppress result code 7
X3 No suppression of result codes
Y Not used
? Indicate the contents of the last read or
modified register
&E Change from AT mode to keyboard dialling
&V<number
>
Set-up a voice call
+++ Escape sequence (register S2). Change from
Data Transfer State to the Command Mode
without clearing the current connection.
Before and after the sequence, no data may
be transferred for 0.5 seconds. The sequence
itself must be received within 0.5 seconds
otherwise is invalid.
T
ABLE
2-14. R
EGISTER
S
OME OF THE REGISTER USED IN THE
H
AYES MODEM ARE NOT APPLIED IN THE
E
RGO
L
INE
D340. W
HEN NOT
USED
,
NOT IMPLEMENTED OR NOT MENTIONED REGISTERS ARE ACCESSED THE VALUE
0
WILL ALWAYS BE
RETURNED
.
A
LL PROGRAMMED VALUES BETWEEN
0
AND
255 (
DECIMAL
)
WILL BE ACCEPTED
.
S0 Value of S1 before a call is automatically
answered. The value 0 prevents automatic
answering of calls
S1 Count of ring signals in 2 second steps until
the call is automatically answered. (The call
will be answered when the value of S0 is
reached.)
S2 Character for escape sequence. Default is
ASCII 43 “+”
S3 Not used character for Carriage Return.
Default is ASCII 13
S4 Not used character for Line Feed. Default is
ASCII 10
S5 Not used character for Back Space. Default is
ASCII 8
S6 Not used Wait Time for Blind Dialling. Default is
ASCII 2
S7 Not used Wait Time for Carrier After Dialling.
The maximum wait time until the connection
is established is 120 seconds. Default is ASCII
30
To Next Page
Loading...
