To Next PageTo Next Page
Need help?Do you have a question about the Philips FW-C399 and is the answer not in the manual?
General| Brand | Philips |
|---|---|
| Model | FW-C399 |
| Category | Stereo System |
| Language | English |
Details on features and board variations across different model versions.
Covers mains voltage, frequency, power consumption, and dimensions.
Details output power, frequency response, and sound features.
Covers FM, MW, and LW tuning ranges, sensitivity, and selectivity.
Details track count, tape speed, wow/flutter, and frequency response.
Covers frequency response, output level, and signal-to-noise ratio.
Describes the test setup for FM tuner measurements.
Describes the test setup for AM tuner measurements.
Outlines the test setup for CD playback measurements.
Describes the test setup for tape recorder measurements.
Lists necessary tools and ESD protection equipment for service.
Lists test cassettes and discs required for service.
Provides guidance on safely handling and soldering chip components.
Details essential precautions for handling components susceptible to electrostatic discharge.
Highlights warnings related to laser product safety and handling.
Step-by-step guide to remove the cassette cover.
Procedure to disassemble the 3CDC module and tuner board.
Instructions for removing the front display and ornamental covers.
Steps to detach the AF9 board and front cabinet from the main unit.
Instructions for removing the rear panel assembly.
Procedure to remove the front board and ETF7 module.
Steps for disassembling the bottom assembly.
Illustration of the unit in Service Position A.
Illustration of the unit in Service Position B.
Illustration of the unit in Service Position C.
Illustration of the unit in Service Position D.
Details on performing tuner tests and accessing service frequencies.
Instructions for activating and deactivating the DEMO mode.
List of error codes and their corresponding descriptions for troubleshooting.
Details the pin assignments for the FTD display.
Table outlining features across different FW-C399 versions.
Schematic diagram for the Key-CDC part.
Component layout for the Key-CDC part.
List of miscellaneous parts used on the front board.
List of capacitors used on the front board.
List of resistors used on the front board.
Continuation of the resistor list for the front board.
List of jumper components used on the front board.
Continuation of the resistor list for the front board.
List of diodes used on the front board.
List of coils and filters used on the front board.
List of transistors and ICs used on the front board.
Block diagram of the ECO6 Tuner Board (Systems non-Cenelec).
Components used for version programming on the tuner board.
Explanation of symbols and abbreviations used in the tuner board diagrams.
Component layout of the ECO6 Tuner Board (componentside).
Component layout of the ECO6 Tuner Board (copperside).
List of miscellaneous parts for the ECO6 tuner board (non-Cenelec).
List of capacitors for the ECO6 tuner board (non-Cenelec).
List of resistors for the ECO6 tuner board (non-Cenelec).
List of diodes for the ECO6 tuner board (non-Cenelec).
List of coils for the ECO6 tuner board (non-Cenelec).
List of transistors for the ECO6 tuner board (non-Cenelec).
List of integrated circuits for the ECO6 tuner board (non-Cenelec).
Block diagram of the ECO6 Tuner Board (Systems Cenelec).
Components used for version programming on the Cenelec tuner board.
Explanation of symbols and abbreviations for the Cenelec tuner board.
Component layout of the ECO6 Tuner Board (Cenelec, componentside).
Component layout of the ECO6 Tuner Board (Cenelec, copperside).
List of miscellaneous parts for the ECO6 tuner board (Cenelec).
List of capacitors for the ECO6 tuner board (Cenelec).
List of resistors for the ECO6 tuner board (Cenelec).
List of diodes for the ECO6 tuner board (Cenelec).
List of coils for the ECO6 tuner board (Cenelec).
List of transistors for the ECO6 tuner board (Cenelec).
List of integrated circuits for the ECO6 tuner board (Cenelec).
Wiring details and variation table for the tape module.
Block diagram of the ETF7 Tape Module.
Overview of the tape mechanism functions and ICs.
Details connector pin assignments for the tape module.
Information on tape deck electronics and adjustment procedures.
Component and chip layouts for the ETF7 Non-Dolby board.
Circuit diagram for the analog section of the tape module.
Circuit diagram for the servo control section.
Exploded views and parts list for the tape module.
List of electrical components for the ETF7 Tape Module.
Explains playback, recording, and dubbing signal modes.
Details ALC, bias, and speed control/adjustment.
Describes Dolby circuit functions including ICs, filters, and muting.
Connector assignments for interfacing with the AF board.
Connector assignments for interfacing with the front board.
Control interface assignments for decks A and B.
Connection details for Deck B heads.
Table for tape adjustment procedures and checks.
Illustrations for head wire soldering on mechanisms A and B.
Explanation of symbols used in the analog circuit diagram.
Table for adjusting tuner circuits.
Explanation of symbols used in the servo control circuit.
List of mechanical parts for the play mechanism.
List of mechanical parts for the record/playback mechanism.
List of mechanical parts for the record/playback mechanism.
List of miscellaneous parts for the ETF7 board.
List of capacitors for the ETF7 board.
List of resistors for the ETF7 board.
List of diodes for the ETF7 board.
List of coils and filters for the ETF7 board.
List of resistors for the AF9 board.
List of diodes for the AF9 board.
List of coils and filters for the AF9 board.
List of transistors and ICs for the AF9 board.
General service hints for the CD changer module.
Block diagram of the 3CDC-LLC-MCD1 CD changer.
Component layout for the CD changer main board.
Circuit diagram for the CD changer main board (Part 1).
Circuit diagram for the CD changer main board (Part 2).
Exploded view of the CD changer module.
List of parts for the CD changer module.
Important cautions before connecting a new CD mechanism.
Steps to manually open the CD changer tray in case of a fault.
Instructions for removing the CD changer tray.
Steps for reassembling the CD changer tray.
Details digital output circuitry and motor control functions.
Covers CD-Text, switch info, timing, protection, and test points.
List of mechanical parts for the CD loader mechanism.
List of mechanical parts for the CD drawer mechanism.
List of miscellaneous parts for the 3CDC-LLC-MCD1 module.
List of capacitors for the 3CDC-LLC-MCD1 module.
List of resistors for the 3CDC-LLC-MCD1 module.
Continuation of the resistors list for the 3CDC-LLC-MCD1 module.
List of coils for the 3CDC-LLC-MCD1 module.
List of diodes for the 3CDC-LLC-MCD1 module.
List of transistors for the 3CDC-LLC-MCD1 module.
List of integrated circuits for the 3CDC-LLC-MCD1 module.
Exploded view of the MMPWR 100W module.
Internal block diagram for the STK442-110 amplifier IC.
List of miscellaneous parts for the amplifier board.
List of capacitors for the amplifier board.
List of resistors for the amplifier board.
List of coils and filters for the amplifier board.
List of diodes for the amplifier board.
List of transistors and ICs for the amplifier board.
Overview of the AF9 board's functions and features.
Table detailing features across different AF9 board versions.
Layouts for the video out part components.
Circuit diagram for the video out part.
List of resistors for the AF9 board.
List of diodes for the AF9 board.
List of coils and filters for the AF9 board.
List of transistors and ICs for the AF9 board.
List of mechanical and accessory parts for the main unit.
List of screws used in the main unit assembly.
