Clock/Timer
]
®
@ 0 @
IMPORTANT!
- When in Eco Power Standby mode, it is
not possible to operate clock or timer
function.
View Clock
The clock (if it is se_) will be sl,own in Standby
mode
To view the clock in any source mode
(CD orTUNER, for example)
• Press CLOCK.TIMER (or CLOCK on the
remote control)
-_ The clock will be disp ayed fur a f_w seconds
-1_ If the clock has not been se*, " ............" wl be
d splayed
Clock Setting
The clock can be set it, either 12hour or
24 hour mode ("Rtl 18:_" or "88:b8" fur
examp}e)
1 Press CLOCK,TIMERtwice
2 Press PROG on the system repea:edy to select
clock mode
-_ If 12bar mode isselected, "R_I Jd,_" will
start flashing
-1_ If 24 hou- mode s selected, "b_:b_" wll start
flashing
3 Press 41_ or _ on the system repeatedly to se_
the haul:
4 Press ]_1 or I_ on the system repeatedly to se_
the minute.
5 Press CLOCK'TIMER asain TOstoro the
setting
-_ The clock will start working
To exit without storing the setting
Press • on the system
Notes:
The clock setting wilt be cancelled when tile
power cord is disconnected or if a power failure
Occurs.
During clock setting, if no button is pressed
within 90 seconds, the system will exit clock setting
mode automatically.
Timer Setting
The system cars swdch ors to CD, TUNER, or
TAPE 2 mode a tumadcally at a preset tme,
serwng as sn alsrm to wake you up
IMPORTANT!
- Before setting the timer, ensure that the
clock is set correctly.
- The timer will always be switched on
after it has been set.
- The timer will not start ira recording is in
progress.
- The volume of the timer will increase
gradually from the minimum level until it
reaches the last tuned volume level.
Press and hold CLOCK'TIMER fur more than
two seconds to select timer mode¸
-_ '_;I ;2 [J_" or "LJL]:_" or the last timer
setting will starL flashing¸
-_ TIMER _) will start flashing¸
-_ The selected sou_e will be Iig_ed while
other available sources are flashing¸
25
pg O01 030/0555/37 Eng 25 12/11/01, 5:25 PM 3139 115 21151
To Next Page
Loading...
