General Information
This system complies with the FCC rules,
Part 15 and with 21 CFR 1040.10.
Operation is subject to the following two
conditions:
- This device may not cause harmful
interference, and
- This device must accept any interference
received, including interference that may
cause undesired operation.
Environmental Information
All nnecessary pac_ging I_as bee_ omitted We
have tried to make the packaging easy to
separate into three materials: cardboard (box),
po ystyrene foam (buffe 0 and polymthy ene (bags,
protective foam sheet)
Your system consists of mater als which can be
recycled and reuscx) if disassembled by a
specialized corr_pan_ Pease observe the local
regu ations regarding the disposal of packag ng
ma:edals, exhausted batter es and old
equipment
Acknowledgement
Energy Star
As an ENERGY STA_
Partner, Philips has
determ ned the: this product
meets the ENERGY STAK _
g delines fur ene-gy effdenc_
Supplied accessories
Remote control
Batteries (two AA size) for remote control
AN loop al,tenna
F:MwJr_ al_tenna
AC power cord
Safety Information
• Befor_ operatir,g the system, check that the
operating voltage indicated on the typeplate (o_-
the voltage ndica* on beside the voltage
se}ector) of your system is identical with the
vo Tsge of yor local power s/@p_ If not, pease
consu}t your- dealer
• Pace the system on a f:at, hard and stabe
gurl_ace
• P ace the system ir_a location with adequate
ventilatior_ to prevent uternal heat b lid up ir_
your system Allow at east 10 cm (4 inches)
clearance f'-om the rear and the top of the nit
and 5 cm (2 inches) from each side
• Do no: expose the system, batteries or discs to
excessive mo stum, rain, sand or heat sources
caused by heating equ pment or drect s_nlight
• If the system is brought directly fi-om a co d to a
warm location, or is placed in a very damp room,
moisture may condense on the lens of the disc
unit inside the system Should this occuq the CD
p}ayer would not operate normall_ Leave the
power on for abot one hour with no disc in the
system until normal playback s possible
• The mechanical parts of the so* contain self
lubr caring bear rigs and must not be oed or
lubr cared
• When the system is switched to Standby
mode, it is still consuming some power.
To disconnect the system from the
power supply completely, remove the AC
power plug from the wall socket.
pg O01 030/0555/37 Eng 8 12/11/01, 5;25 PM 3139 115 21151
To Next Page
Loading...
