EasyManua.ls Logo

Philips FW M355 - System Specifications

Philips FW M355
78 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1-3
SPECIFICATIONS
GENERAL:
Mains voltage : 110-127V/220-240V Switchable for /21M
220-230V for /22/34
120V for /37
Mains frequency : 50/60Hz
Power consumption : < 80W Active
< 15W at Standby with Clock on
< 0.5W at ECO Standby /22
Clock accuracy : < 4 seconds per day
Dimension centre unit : 265 x 310 x 365mm
TUNER:
FM
Tuning range : 87.5-108MHz
65.81-74MHz for /34
1)
Grid : 50kHz (& 30kHz for /34)
100kHz for /21M/37
IF frequency : 10.7MHz ± 20kHz
Aerial input : 75 coaxial
Sensitivity at 26dB S/N : < 7µV
Selectivity at 600kHz bandwidth : > 25dB
IF rejection : > 60dB [80dB]
Image rejection : > 25dB [75dB]
Distortion at RF=1mV, dev. 75kHz : < 3%
-3dB Limiting point : < 8µV
Crosstalk at RF=1mV, dev. 40kHz : > 18dB
MW
Tuning range : 531-1602kHz
530-1700kHz for /21M/37
Grid : 9kHz
10kHz for /21M/37
IF frequency : 450kHz ± 1kHz
Aerial input : Frame aerial
Sensitivity at 26dB S/N : < 4.4mV/M [4.0mV/M]
Selectivity at 18kHz bandwidth : > 18dB
IF rejection : > 45dB
Image rejection : > 28dB
Distortion at RF=50mV, m=80% : < 5%
AMPLIFIER:
Output power : 2 x 40W RMS
2)
2 x 33W FTC
3)
Frequency response within -3dB : 50Hz-15kHz
Dynamic Bass Boost : DBB ON, DBB 1, DBB 2, DBB 3
4)
Digital Sound Control : Jazz, Techno, Optimal, Rock
4)
Headphone output, R
LOAD
= 32 : 15mW ± 2dB
Input sensitivity, R
S
= 600
Aux / CDR : 500mV / 1.0V
Mic : {3.5mV}
CASSETTE RECORDER:
Number of track : 2 x 2 stereo
Tape speed : 4.76 cm/sec +2.5/-1.5%
Wow and flutter : < 0.4% DIN
Fast-wind/rewind time C60 : 130 sec
Bias system : 78kHz ± 10kHz
Rec/Pb frequency response within 8dB : 80Hz - 12.5kHz
Signal to noise ratio Type I : > 48dBA
VCD/COMPACT DISC:
Audio Performance:
Measurement done at output conn. of the 3CDC module.
Frequency response within ± 3dB : 20Hz - 20kHz
Output level (in Vrms) : 500mV ± 1.5dB, R
out
= 100
Signal/Noise ratio (A-weighted) : > 80dBA
Distortion at 1kHz : < 0.003%
Channel unbalance at 1kHz : ±1dB
Channel separation at 1kHz : > 60dB
De-emphasis : 0 or 15/50 mS (Switched by subcode
on the disc)
MPEG 1 Layer 3 (MP3-CD) : MPEG AUDIO
MP3-CD bit rate : 56-256 kbps
MP3-CD sampling frequencies : 32kHz, 44.1kHz,
48kHz
Recording Format : ISO 9660
UDF format not supported.
Video Performance
(for VCD version only)
:
Video output level : 1.0V ± 0.2V
Luminance non-linear distortion : < 0 ± 5%
Luminance S/N ratio : > 50dB
{....} Values for /21/21M only
[....] Values for Cenelec Tuner version only
1)
Default setting is OFF, to switch on please refer page 3-1.
2)
6, 1kHz, 10% THD
3)
6, 60-12500Hz, 10% THD
4)
Frequency response in each setting is software controlled.

Table of Contents

Other manuals for Philips FW M355

Related product manuals