Philips FX30 - Preparing the Remote Control; Automatic Radio Station Installation; Setting the System Clock

9EN
• Connect the AC power cable to the wall
socket.
Prepare the remote control
Note
• Risk of explosion! Keep batteries away from heat,
sunshineorre.Neverdiscardbatteriesinre.
• Danger of explosion if the battery is incorrectly
replaced. Replace only with the same or equivalent
type.
1 Open the battery compartment.
2 Insert one AAA battery with correct
polarity (+/-) as indicated.
3 Close the battery compartment.
Note
• If you are not going to use the remote control for a
long time, remove the battery.
• Batteries contain chemical substances, so they should
be disposed of properly.
Install radio stations
automatically
When you connect power and no radio
stations are stored, the unit automatically begins
to store radio stations.
1 Connect the unit to power supply.
» [AUTO INSTALL - PRESS PLAY KEY]
(auto install - press the PLAY key) is
displayed.
2 Press on the remote control to start
installation.
» [AUTO] (auto) is displayed.
» The unit automatically stores radio
stationswithsufcientsignalstrength.
» When all the available radio stations
arestored,therstpresetradiostation
is broadcast automatically.
Set clock
1 In standby mode, hold CLOCK/DISPLAY
for more than two seconds to activate
clock setting.
» 'CLOCK SET' is displayed. Then, the 12
hour or 24 hour format is displayed.
2 Press / repeatedly to select 12 hour
or 24 hour format.
3 Press CLOCK/DISPLAYtoconrm.
» The hour digits are displayed and begin
to blink.
4 Press / repeatedly to set the hour,
then press CLOCK/DISPLAYtoconrm.
» The minute digits are displayed and
begin to blink.
5 Press / repeatedly to set the minute,
then press CLOCK/DISPLAYtoconrm
the set clock.