Philips FX30 - Listening to the Radio; Tuning and Scanning Radio Stations; Programming Radio Presets

17EN
8 Listen to radio
Tune to a radio station
1 Press SOURCE repeatedly to select FM
or AM.
2 Press and hold / for more than two
seconds.
» [SEARCH] (search) is displayed.
» The radio tunes to a station with
strong reception automatically.
3 Repeat step 2 to tune to more stations.
• To tune to a weak station, press /
repeatedlyuntilyoundoptimal
reception.
Program radio stations
automatically
You can program a maximum of 20 FM and 10
AM preset radio stations.
• In tuner mode, press and hold PROG
for more than two seconds to activate
automatic programming.
» [AUTO] (auto) is displayed.
» All available stations are programmed
in the order of waveband reception
strength.
» Therstprogrammedradiostationis
broadcast automatically.
Program radio stations
manually
You can program a maximum of 20 FM and 10
AM preset radio stations.
1 Tune to a radio station.
2 Press PROG to activate program mode.
3 Press / to allocate a number to this
radio station, then press PROGtoconrm.
4 Repeat the above steps to program other
stations.
Tip
• To overwrite a programmed station, store another
station in its place.
Select a preset radio station
• In tuner mode, press / to select a
preset number.
Tip
• Position the antennas as far as possible from TV, VCR or
other radiation source.
• For optimal reception, fully extend and adjust the
position of the antennas.
Change AM tuning grid
In some countries, the AM radio frequency step
between adjacent channels is 10 kHz (9 kHz in
some areas).
1 Select the tuner source.
2 Press and hold on the main unit for
morethanveseconds.
» All preset stations are erased and need
to be re-programmed.