7 Rinse the outside of the brew group under a lukewarm tap.
Warning: Never use any washing-up liquid or other cleaning
agent to clean the brewing unit.
Warning: Do not dry the brew group with a cloth to prevent fibers
from collecting inside the brewing unit.After rinsing, just shake
excess water off the brewing unit or let it air-dry.
8 Before you slide the brew group back into the machine, make sure the
two reference signs on the side match. If they do not match, perform the
following step:
-
Make sure the lever is in contact with the base of the brew group.
9 Make sure the locking hook of the brew group is in the correct position.
-
To position the hook correctly, push it upwards until it is in uppermost
position.
Note:The hook is not correctly positioned if it is still in bottommost
position.
20
English
To Next Page
Loading...
