34
The descaling cycle is activated.
The bar shows the cycle's progress.
If the containers need to be emptied,
press the "PAUSE" button.
Then, press the "START" button when the
container has been emptied and replaced.
At the end of the rst step, when the
descaling solution is nished, the
machine will require a tank rinse.
Rinse the water tank and re ll it with
fresh drinking water.
Then, press the "OK" button.
Empty the drip tray placed under the
dispensing spout (page 38 - g. 2) and
then replace it on the machine.
Then, press the "OK" button.
Empty the drip tray placed under the
dispensing spout (page 38 - g. 2) and
replace it back onto the machine.
Then, press the "OK" button.
Place a container under the dispensing
spout and a container under the hot
water wand.
Then, press the "OK" button.
Fill half the carafe with fresh water
(page 36).
Insert the carafe and place it in the
brewing position. Then, press the "OK"
button.
Completely empty the carafe and ll it
with fresh water (page 36).
Insert the carafe and place it ready for
brewing. Then, press the "OK" button.
A default amount of water is needed for the rinsing step. This allows performing an ideal rinse cycle to ensure the best conditions to
brew products. The message about lling the tank for the rinse cycle is normal, as it is part of the procedure.
MAINTENANCE
To Next Page
Loading...
