24
English
3 Use a brush with soft bristles (e.g. a toothbrush) to remove dust or fluff from
the side brush and the robot.
Tip: You can use the brush end of the cleaning tool to remove dust or fluff
from the side brush and the robot.
4 Attach the side brush by clicking it into the correct position on the bottom of
the robot.
Cleaning the main wheels and the front caster wheel
1 Put the robot upside down on a surface that is flat and stable.
2 Use a brush with soft bristles (e.g. a toothbrush) to remove dust or fluff from
the front caster wheel and main wheels.
You can use the brush end of the cleaning tool to remove dust or fluff
from the wheels.
Cleaning the sensors, contact points and IR signal window
To maintain good cleaning performance, you have to clean sensor, contact
points and IR signal window from time to time.
1 Unplug the station from the wall socket
2 Use a soft non-abrasive dry cloth. If necessary, lightly moisten the cloth.
3 Clean the components.
Note: Do not use cleaning detergents.
22 / 789 21 / 787 22 / 789
To Next Page
Loading...
