Philips HTL3320 - Power Connection; Subwoofer Pairing

10
AUX
AUDIO OUT
L
R
• UseaRCAto3.5mmaudiocable(not
included) to connect the TV’s audio output
sockets to the AUX socket on the unit.
Connect to Power
• BeforeconnectingtheACpowercord,
ensure you have completed all other
connections.
•
Risk of product damage!
Ensure that
the power supply voltage corresponds
to the voltage printed on the back or the
underside of the unit.
• ConnectthemainscabletotheAC~Socket
of the unit and then into a mains socket
• ConnectthemainscabletotheAC~Socket
of the subwoofer and then into a mains
socket.
Pair up with the subwoofer
Automatic Pairing
Plug the Soundbar and the subwoofer into the
mains sockets and then press on the unit or
remote control to switch the unit to
ON
mode.
The subwoofer and Soundbar will automatically
pair.
• Whenthesubwooferispairingwith
the Soundbar the
Pair
indicator on the
subwoofer will flash fast.
• Whenthesubwooferispairedwith
the Soundbar, the Pair indicator on the
subwoofer will light up steadily.
• DonotpressPairontherearofthe
subwoofer, except for manual pairing.
Manual Pairing
If no audio from the wireless subwoofer can be
heard, manually pair up the subwoofer.
1
Unplug both units from the mains sockets
again, then plug them in again after 3
minutes.
2
Press and hold the
PAIR
button on the rear
of the subwoofer for a few seconds.
The Pair indicator on the subwoofer will
rapidly blink.
3
Then press on the unit or remote control
to switch the unit ON.
The
Pair
indicator on the subwoofer will
become solid when successful.
4
If the Pair indicator still keeps blinking,
repeat step 1-3.
Tip
• Thesubwoofershouldbewithin6mofthe
Soundbar in an open area (the closer the better).
• Removeanyobjectsbetweenthesubwooferand
the Soundbar.
• Ifthewirelessconnectionfailsagain,checkif
there is a conflict or strong interference (e. g.
interference from an electronic device) around
the location. Remove these conflicts or strong
interferences and repeat the above procedures.
• Ifthemainunitisnotconnectedwiththe
subwoofer and it is in ON mode, the unit’s
POWER indicator will flash.