Philips HTL3320 - USB Playback; Wall Mounting; Mounting Instructions

13
English
Tip
• WhileinOPTICAL/HDMIARCmode,ifthere's
no sound output from the unit and the status
Indicator flashes, you may need to activate
PCM
or
Dolby Digital
Signal output on your source device
(e.g. TV, DVD or Blu-ray player).
USB Operation
Enjoy audio on a USB storage device, such as an
MP3 player and USB flash memory, etc.
1
Insert the USB device.
2
Press the
Source
button repeatedly on the
unit or press the
USB
button on the remote
control to select
USB
mode.
3
During playback:
Button Action
Start, pause or resume play.
/ Skip to the previous or next track.
Tip
• TheunitcansupportUSBdeviceswithupto32
GB of memory.
• ThisunitcanplayMP3/WAV/WMA.
• SupportaUSBport:5V , 500mA.
5 Wall mount
Note
• Improperwallmountingmayresultinaccident,
injury or damage. If you have any query, contact
Consumer Care in your country.
• Beforewallmounting,makesurethewallcan
support the weight of your Soundbar.
• Beforewallmount,youneednotremovethe
four rubber feet at the bottom of the Soundbar,
otherwisetherubberfeetcannotbexedback.
Screw length/diameter
Depending on the type of wall mounting your
Soundbar, make sure that you use screws of a
suitable length and diameter.
3.5-4mm
4mm
> 25 mm
See the illustration in the quick start guide on
how to wall mount the Soundbar.
1) Drill two holes on the wall.
2) Secure the dowels and screws in the holes.
3) Hang the SoundBar on the fastening screws.