Philips HTS-3510 - Page 13

- 2-6 -
2-2) Insert the upgrade Disc into the DVD player slot, then the DVD player reads the
Disc and upgrade the Firmware itself as followings
Status FLD display on DVD player
• Detect the upgrade Disc No display
• Read the Disc Cd rEAD XX(XX: Program counter)
• Erased the Flash memory FLASH ERA
• Written the Flash memory FLASH XX(XX: Program counter)
• Verified the Flash memory FLASH XX(XX: Program counter)
• Completed the upgrade FINISHED
Note: After completed, plug the Power cord out and in again, and then press the Open key, then the
Disc will be ejected.
Caution: While CD detecting and reading, if Open key or Power is pressed Then download
procedure will be aborted.
3. DVD player with CD-RW option
(for models using NS MPEG chip, marking on the IC is PANTERA)
3-1) Make the DVD program upgrade Disc as following procedure
*Recommended S/W: adaptec Easy CD Creater
*use file format: ISO9660
• Format the CD-RW Disc as below.
Make the Folder name to “lg_dvd UPGRADE lg” under root folder
( lg_dvd_firmware upgrade lg)
• Download the source file in the folder
(Ex, If the source file is “lg_a3_korea.bin, “lg_dvd firmware upgrade lg lg_a3_korea.bin”)
3-2) UPgrade the firmware for DVD player as followings
ACTION FLD display on dvd player
• Insert the upgraded Disc into the DVD player solt Press Up
then starts the detecting
• Press the UP key on the Remote controller READ 0(If error is occurred, displayed
then starts the reading retry counter)
- Starts the upgrading UPGRADE 0(If error is occurred, displayed
retry counter)
- Completed the upgrading FINISHED ➞ checksum
- Opened the Tray Disc (“FINISHED ➞ checksum” is displayed
repeatedly at 2 second intervals)
• Plug the Power Cord out
Note: In the status of FLD with “READ 0” or “UPGRADE 0”
If an error is occured, the read counter, “READ 0”, shows retry counter or “ERROR num”
If the num has 0~2, retry the firmware upgrade procedure.
If the error is continued after retrying 5 times, replace the Flash ROM IC.
W W W
W W
W W W W