Philips HTS5131 - MP3 Player; Ipod or Iphone

22
MP3 player
Connect your MP3 player to play your audio les
or music.
What you need
• An MP3 player.
• A 3.5mm stereo audio cable.
Play music
1 Connect the MP3 player to the home
theater as described in the quick start guide.
2 Press SOURCE repeatedly until MUSIC
I-LINK appears on the display panel.
3 Press the buttons on the MP3 player to
select and play audio les or music.
iPod or iPhone
When you connect a Philips dock for iPod/iPhone,
you can use the home theater to play music,
movies and photos from your iPod or iPhone.
What you need
• A Philips dock (Model: Philips DCK3060).
• A yellow composite cable.
Note
•
Charge your iPod/iPhone on the dock while
the home theater is in iPod mode.
Dock your iPod or iPhone
1 Move the slide at the bottom of the dock to
STANDARD, and then connect the dock to
the home theater.
2 Connect the yellow composite cable to the
dock and TV.
3 Switch on the iPod or iPhone, and place it
on the dock.
Button Action
/ or
Alphanumeric
buttons
Select a preset radio station.
Navigation
buttons (left/
right)
Search for a radio station.
Navigation
buttons (up/
down)
Fine tune a radio frequency.
Press to stop the installation of
radio stations.
BACK
Press and hold to erase the
preset radio station.
OPTIONS
Manual: Press once to access
program mode, and press
again to store the radio
station.
Automatic: Press and hold for
three seconds to reinstall the
radio stations.
RADIO Toggle between the stereo
and mono sounds.
Listen to radio
1 Press RADIO.
• To listen to a preset station, press
or
.
• To search for a radio station, and then
listen, press Navigation buttons (left/
right).
2 Press +/- (Volume) to change the volume.
Tuning grid
In some countries, you can toggle the FM tuning
grid between 50 kHz and 100 kHz. Switching the
tuning grid erases all preset radio stations.
1 Press RADIO.
2 Press .
3 Press and hold (Play) to toggle between
50 kHz or 100 kHz.
EN