Philips HU4816 - Using the Humidifier; Water Level and Refilling

8 EN
Note
• If no preset humidity level is selected,
the humidity indication light will be o.
Water level
When there is not enough water in the
water tank, the appliance will work in
the following ways.
• The water level drops and the red
indicator light starts blinking
(g. h).
• The humidier continues to work for
30 minutes and then stops working,
the red
indicator light remains on.
The appliance will resume work when
you rell water into the water tank.
Note
• If the water tank is empty when the
humidier is plugged in and switched
on, the red indicator light blinks for
2 minutes and then remains on before
the water tank is relled with water.
• It is normal to nd some water left in the
tank.
Relling water
Water level can be observed through
the transparent water tank window.
1 Switch o the humidier and unplug
it.
2 Remove the upper unit by holding it
at both sides (g. b).
3 Fill the water tank with cold tap
water until water reaches the
maximum water indication level
(g. f).
Note
• When lling water, do not exceed the
maximum water level, or water might
leak from the air inlets.
• Do not shake the water tank when
moving it, or water might leak from the
air inlets.
• Do not ll water through the air outlets
on top of the humidier.
4 Place the upper unit back onto the
water tank (g. g).