9EN
5 Cleaning your
humidifier
Note
• Always unplug the humidier before you
clean it.
• When pouring water from the water
tank, make sure to pour water from the
opposite side of the air inlets.
• Never use abrasive, aggressive, or
ammable cleaning agents such as
bleach or alcohol to clean any part of
the humidier.
• It is normal to have dust inside upper
unit of the appliance after using it for a
while. User cannot clean it by himself.
Please contact local service center for
support.
Cleaning the body of the
humidier
Regularly clean the inside and outside
of the humidier to prevent dust from
collecting.
1 Wipe away dust with a soft dry cloth
from the body of the humidier.
2 Clean the air inlet and the air outlet
with a soft dry cloth.
Cleaning the water tank
Clean the water tank every weeks to
keep it hygienic.
1 Take out the humidication lter
and the lter support.
2 Fill the water tank for 1/3 with water.
3 Add some mild washing-up liquid to
the water in the water tank.
4 Clean the inside of the water tank
with a soft clean cloth.
5 Empty the water tank into a sink.
6 Put the humidication lter and the
lter support back into the water
tank.
Cleaning the
humidication lter
Clean the humidication lter every
week to keep it hygienic.
1 Take out the humidication lter
and the lter support from the
water tank (g. n).
2 Remove the humidication lter
from the lter support (g. o).
3 Soak the humidication lter in
cleansing agent (e.g diluted citric
acid solution) for one hour (g. p).
Note
• Please use mid or acid cleanser
(24g citric acid with 4L water).
4 Rinse the humidication lter
under a slowly running tap. Do not
squeeze or wring the lter when
cleaning (g. q) .
5 Let excess water drip o the
humidication lter.
6 Assemble the humidication lter
round the lter support (g. d).
7 Put the humidication lter and the
lter support back into the water
tank (g. e).
8 Put the upper unit back onto the
water tank (g. g).
Note
• Do not squeeze or wring the lter. This
might damage the lter and impact
humidication performance.
• Do not dry the lter under direct
sunlight, unless it is assembled back
onto the lter support