Philips iPlayer 3 - Introduction to iPlayer 3 Modes

INTRODUCTION
10
Introduction to iPlayer 3 Modes
The iPlayer 3 controller has three modes of operation:
• USB Mode. You use USB Mode to transfer data between the
iPlayer 3 and ColorPlay 3 software on your PC or Mac. See
Setting Up the iPlayer 3 in USB Mode on page 14 and
Chapter
3: USB Mode on page 20.
• Run Mode. You use Run Mode to play light shows. See
Setting Up the iPlayer 3 in Run Mode on page 16 and
Chapter
4: Run Mode on page 23.
• Configuration Mode. You use Configuration Mode to:
– Set up and display general information, such as date and
time, latitude and longitude (for sunrise/sunset
calculation), and firmware version number.
– Define or customize triggers and alarms.
See Setting Up the iPlayer 3 in Configuration Mode on page
17 and Chapter
5: Configuration Mode on page 26.