121
10.3. Requirement After Parts Replacement
Replaced circuit board assembly or part
Required adjustment Remarks
IC0007 (Flash memory on CONTROL Board) or
CONTROL Board
1. Adjust Shading.
IC0004 (EEPROM on CONTROL Board) or CONTROL
Board
1. Adjust Shading.
2. Adjust Individual position manually, as required.
3. Execute Double Feed (See 9.3.7) to adjust double
feed sensitivity.
4. Execute Bent Paper Sensor (See 9.3.7.) to adjust
sensor level.
5. Set USB ID. (See 9.3.7.)
Note:
When the initial settings to this product are other than
the default (factory setting), this scanner will require
the resetting.
(Item) (Default (Factory Setting))
Sleep Mode 15 minutes
Caution Setting (Roller Cleaning Timing) 20,000
Caution Setting (Roller Replacement Timing) 350,000
Feed Speed 100 %
Starting Sensor or STARTING SENSOR Board 1. Adjust Vertical Position (for Front and Back) and
Length in individual Position or adjust All Position
USS Waiting Board 1. Execute Double Feed (See 9.3.7) to adjust double
feed sensitivity.
USR Board 1. Execute Double Feed (See 9.3.7) to adjust double
feed sensitivity.
Optical Unit Front 1. Adjust Shading.
2. Adjust All Position or the following adjustment should
be needed.
a. Adjust Front Vertical Position in Individual
Position.
b. Adjust Front Horizontal Position in Individual
Position.
Optical Unit Back 1. Adjust Shading.
2. Adjust All Position or the following adjustment should
be needed.
a. Adjust Back Vertical Position in Individual Position.
b. Adjust Back Horizontal Position in Individual
Position.
Reference Plate (F) 1. Adjust Shading.
Reference Plate (B) 1. Adjust Shading.
Drive Roller 1. Adjust Vertical Position (for Front and Back) and
Length in individual Position or adjust All Position.
Exit Roller 1. Adjust Vertical Position (for Front and Back) and
Length in individual Position or adjust All Position
Others (when assembling or disassembling parts which
will affect the scanning positions.)
1. Adjust the following adjustment or All Position.
a. Adjust Front Vertical Position in Individual
Position.
b. Adjust Front Horizontal Position in Individual
Position.
c. Adjust Back Vertical Position in Individual
Position.
d. Adjust Back Horizontal Position in Individual
Position.
BENT PAPER S(L) SENSOR Board
BENT PAPER S(R) SENSOR Board
BENT PAPER R(L) SENSOR Board
BENT PAPER R(R) SENSOR Board
1. Execute “Bent Paper Sensor” (See 9.3.7.) to adjust
sensor level.
To Next Page
Loading...
