Philips KV-S5055C - List of Functions for Service Utility

87
9.2. List of Functions for Service Utility
Service Utility item list is as follows.
Note:
When two or more scanners are connected to a PC, execute “Select Scanner” to specify the scanner before evaluating.
The procedure is as follows.
1. Click “Select Scanner” on the main menu.
2. Select the product number of the scanner to evaluate.
Item Purpose Remarks
Scanner Status
*2
Used to indicate scanner status (Ready, Error, or Caution) 2
Scanner Information
*2
Used to indicate scanner information such as Model, firmware
version, board revision, memory size, interface, Interface
condition, etc.
2
Scanner Counter
Update All Counters
*2
Used to update the values of System Counter, Cleaning Roller
Counter, and Replacing Roller Counter
1, 6
Clear Counter
(After Clean Roller)
*2
Used to reset the Roller Cleaning Counter to zero after cleaning
the rollers
1, 6
Clear Counter
(After Replace Roller)
*2
Used to reset the Roller Replacement Counter to zero after
replacing the rollers
1, 6
Scanner Condition
Sleep Mode
*2
Used to set “Waiting Time” before entering the Sleep Mode 1
Clean Imprinter
*1 *2
Used to clean the ink jet head of the imprinter 6
Buzzer Setting
*2
Used to set the Buzzer ON/OFF condition 1
User Shading
*2
Used to execute shading correction at the user side, or to restore
the shading data to the default (Factory-setting)
4
Caution Setting
*2
Used to set the number of the document scanning that enables
the Service Utility to inform the caution information (roller
replacement timing and roller cleaning timing)
1, 3
Set Default Used to set “Sleep Mode”, “Caution Setting”, and
“Feed Speed” to the default
3
Test LED Used to periodically light the indicators on the front cover 5
Key / Sensor Used to do keys' or sensors' ON/OFF test 5
Sensor Sensitive Level Used to check the status (Offset level, Slice level) of each Sensor
(Waiting, Slip Detect, Starting, Exit)
5
Feed Motor Used to check the operation of the motor periodically rotating in
the paper-feed direction and its reverse direction
Note:
• Rotating in the paper-feed direction will allow the Paper
Feed Roller Module to go down to perform the paper-feed
function.
• Rotating in the reverse direction will allow the Paper Feed
Roller Module to rise to perform the paper-separation
function.
5
Conveyor Motor Used to check Conveyor Motor rotation 5
DFP Pressure Drive Used to check DFP Pressure Motor rotation 5
Gate Drive Used to check the open/close operation of the gate by rotating
the Conveyor Motor in the paper-feed direction or its reverse
direction.
5
Feed Used to check paper feed condition 5
Sleep Mode Used to check whether the sleep mode function works properly 5
CCD Level Used to check the peak output-level after setting CCD lighting
level on each side
5
Image Sensor Output Used to check whether CCD operates normally by outputting the
CCD's output level or whether a dust is attached on the Scanning
Glass
5
Double Feed Used to check the level of the Double Feed Detector (R)
(Response level) after setting the ultrasonic emission level of the
Double Feed Detector (G)
5
Memory Used to execute memory R/W test 5
Ionizer Used to check whether ON/OFF (Enable/Disable) control to
output Ionizer properly operates.
5