125
CN1006 (CONTROL Board) - CN5003 (CCD (B) Board)
Pin No. Signal Name Description
CN1006 CN5003
1 1 12V 12V supply
2 2 GND Ground
3 3 5V 5V supply
4 4 GND Ground
5 5 3.3V 3.3V supply
6 6 GND Ground
7 7 AFE_CLK AFE serial clock
8 8 AFE_SDI AFE serial data out
9 9 AFE_SENB AFE serial enable
10 10 LSYNC_B Line sync
11 11 *SRES Reset
12 12 AFE_SDOB AFE serial data in
13 13 CCD_AFE_REV CCD_AFE Board revision
14 N.C. N.C.
CN1007 (CONTROL Board) - CN2001 (USR RELAY Board)
Pin No. Signal Name Description
CN1007 CN2001
1 1 JS_DATA Double feed detector sensor out
2 2 DFP_HOME DFP home detect
3 3 GND Ground
4 4 ENDING Paper exit
5 5 *PEXIST Paper detect
6 6 5VSLP +5V for sensor
7 7 12V +12V for analog
8 8 ATT_ON Amplifer gain down
CN1008 (CONTROL Board) - CN2006 (USS RELAY Board)
Pin No. Signal Name Description
CN1008 CN2006
1 18 5VSLP +5V for sensor
2 17 START Paper Start (analog)
3 16 IMPSTART Slip Detect (analog)
4 15 JS_GAIN Ultra sonic output level
5 14 GND Ground
6 13 U_CLK USS RELAY Board I/F clock
7 12 U_LD USS RELAY Board I/F Load
8 11 U_DOUT USS RELAY Board I/F data uot
9 10 U_DIN USS RELAY Board I/F data in
10 9 JS_CLK Ultra sonic out clock
11 8 GND Ground
12 7 3V +3.3V
13 6 GND Ground
14 5 24VIL +24V through interlock switch
15 4 14V +14V for sensor
16 3 14V +14V for sensor
17 2 GND_LED +14V_Ground
18 1 WAIT Wait
To Next Page
Loading...
