51
8.4.4. Sub Conveyor Plate
8.4.5. STARTING SENSOR Board
1. Push the ADF Door Release to open the ADF Door.
2. Remove the 2 screws.
3. Remove the 2 screws (1 from each side).
4. Remove the Sub Conveyor Plate from the scanner.
Reassembling Note:
When reassembling the Sub Conveyor Plate, be sure to
insert the plate inside the claws of the Sub Chassis R
and Sub Chassis L.
1. Remove the Sub Conveyor Plate. (See 8.4.4.)
2. Release the poly-slider that holds the Free Roller shaft.
3. Remove the Free Roller Assembly.
To Next Page
Loading...
