Philips KV-S5055C - Page 56

56
8.4.9. BENT RELAY Board
8.4.10. USS / WAITING SENSOR Board
8.4.11. BENT PAPER S (R) Board and BENT PAPER R (R) Board
1. Remove the Imprinter Door. (See 8.3.1.)
2. Remove the Top Cover. (See 8.4.8.)
3. Release the 2 connectors from the clampers.
4. Disconnect the 5 connectors to the BENT RELAY Board.
5. Remove the 2 screws on the BENT RELAY Board.
1. Remove the Imprinter Door. (See 8.3.1.)
2. Remove the Top Cover. (See 8.4.8.)
3. Remove the screw on the USS / WAITING SENSOR Board.
4. Disconnect the connector to the USS / WAITING SENSOR
Board.
1. Remove the Imprinter Door. (See 8.3.1.)
2. Remove the Top Cover. (See 8.4.8.)
3. Remove the spring to release the Lock Assembly from the
scanner.
4. Remove the Lock Assembly.