Philips MC235 User Manual

8
3140 115 xxxxx
English
General Information
This set complies with the FCC rules,
Part 15 and with 21 CFR 1040.10.
Operation is subject to the following two
conditions:
– This device may not cause harmful
interference, and
– This device must accept any interference
received, including interference that may
cause undesired operation.
Environmental Information
All unnecessary packaging has been omitted. We
have tried to make the packaging easy to
separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene
(bags, protective foam sheet).
Your system consists of materials which can be
recycled and reused if disassembled by a
specialized company. Please observe the local
regulations regarding the disposal of packaging
materials, exhausted batteries and old
equipment.
Supplied accessories
–2 speaker boxes
– remote control (with battery)
– AM loop antenna
– FM wire antenna
– stand
– screw and plug assembly x2
Safety Information
● Before operating the system, check that the
operating voltage indicated on the typeplate (or
the voltage indication beside the voltage
selector) of your system is identical with the
voltage of your local power supply. If not, please
consult your dealer.
● Place the system on a flat, hard and stable
surface.
● Install the unit near the AC outlet and where the
AC power plug can be easily reached.
● The apparatus shall not be exposed to
dripping or splashing.
● Place the system in a location with adequate
ventilation to prevent internal heat build-up in
your system. Allow at least 10 cm (4 inches)
clearance from the rear and the top of the unit
and 5 cm (2 inches) from each side.
● The ventilation should not be impeded by
covering the ventilation openings with items,
such as newspapers, table-cloths, curtains, etc.
● Do not expose the system, batteries or discs to
excessive moisture, rain, sand or heat sources
caused by heating equipment or direct sunlight.
● No naked flame sources, such as lighted candles,
should be placed on the apparatus.
● No objects filled with liquids, such as vases, shall
be placed on the apparatus.
● If the system is brought directly from a cold to a
warm location, or is placed in a very damp room,
moisture may condense on the lens of the disc
unit inside the system. Should this occur, the CD
player would not operate normally. Leave the
power on for about one hour with no disc in the
system until normal playback is possible.
● The mechanical parts of the set contain self-
lubricating bearings and must not be oiled or
lubricated.
● When the system is switched to Standby
mode, it is still consuming some power.
To disconnect the system from the
power supply completely, remove the AC
power plug from the wall socket.
pg001-017_MC235B_37_Eng 9/2/07, 13:458

Philips MC235 Specifications

General

Display type	LCD
Backlight color	Blue
Backlight display	Yes
Apple docking	No
Headphone connectivity	3.5 mm
Playback modes	Program, Repeat, Shuffle
Channels quantity	40 channels
Disc types supported	CD, CD-R, CD-RW
Audio formats supported	-
FM band range	87.5 - 108 MHz
MW band range	531 - 1602 kHz
Supported radio bands	FM, MW
Preset stations quantity	40
Impedance	4 Ω
Speaker type	2-way
Frequency range	63 - 16000 Hz
RMS rated power	10 W
Woofer diameter	76 mm
Number of speakers	2
Signal-to-Noise Ratio (SNR)	62 dB
Peak Music Power Output (PMPO)	400 W
Type	Home audio micro system
Product color	Grey, Silver
Disc loading type	Front
Network integrated ports	3.5mm stereo line in
Power source	AC
Input voltage	220-240 V
Input frequency	50 Hz
Power consumption (standby)	4 W

Weight and Dimensions

Depth	96 mm
Width	250 mm
Package depth	300 mm
Package width	328 mm
Package height	313 mm
Package weight	5300 g
Main speaker width	166 mm
Main speaker height	245 mm