15
English
Turn on Progressive Scan
Progressive scan displays twice the number of
frames per seconds than interlaced scanning
(ordinary TV system). With nearly double the
number of lines, progressive scan offers higher
picture resolution and quality.
Before you turn on this feature, ensure that:
The TV supports progressive scan
signals.
You have connected this unit with the
TV through component video.
1 Turn on the TV.
2 Ensure that the TV progressive scan mode
is deactivated (see the TV user manual).
3 Switch the TV to the correct viewing
channel for this unit.
4 Press DISC.
5 Press SYSTEM MENU.
6 Press / to select [Video Setup
Page] in the menu, then press
.
7 Select [Component] > [Pr/Cr Pb/Cb Y],
then press OK.
8 Select [TV Mode] > [Progressive], then
press OK.
9 To proceed, select [OK] and press OK.
» The progressive setup is complete.
Note
If a blank/distorted screen is displayed, wait for 15
seconds for auto recovery or turn off progressive scan
manually.
10 Turn on the progressive scan mode on the
TV.
2 Press DISC to switch to disc mode.
3 Turn on the TV and switch to the correct
video-in channel in one of the following
ways:
Go to the lowest channel on your TV,
then press the Channel Down button
until you see the Philips screen.
Press the source button repeatedly on
the remote control of your TV.
Tip
The video-in channel is between the lowest and highest
channels and may be called FRONT, A/V IN, VIDEO etc.
See the TV user manual on how to select the correct
input on the TV.
Select the correct TV system
Change this setting if the video does not appear
correctly. By default, this setting matches the
most common setting for TVs in your country.
1 Press SYSTEM MENU.
2 Select [Preference Page].
3 Select [TV Type] and then press .
4 Select a setting and then press OK.
[PAL] - For TV with PAL color system.
[Auto] - For TV that is compatible
with both PAL and NTSC.
[NTSC] - For TV with NTSC color
system.
5 To exit the menu, press SYSTEM MENU.
Change system menu
language
1 Press SYSTEM MENU.
2 Select [General Setup Page].
3 Select [OSD Language] and then press .
4 Select a setting and then press OK.
5 To exit the menu, press SYSTEM MENU.
EN
To Next Page
Loading...
