23
Show RDS information
RDS (Radio Data System) is a service
that allows FM stations to show additional
information. If you tune to a RDS station, a RDS
icon and the station name are displayed.
When automatic programming is used, RDS
stations are programmed first.
1 Tune to a RDS station.
2 Press RDS/CLOCK repeatedly to scroll
through the following information (if
available):
Station name »
Program type such as » [NEWS] (news(,
[SPORT] (sport), [POP M] (pop
music)...
Frequency »
2 Press PROG to activate program mode.
[PROG] blinks on the display. »
3 Press / to allocate a number (1 to 20)
to this radio station, then press PROG to
confirm.
The preset number and the frequency »
of the preset station are displayed.
4 Repeat the steps above to program other
stations.
Note
To overwrite a programmed station, store •
another station in its place.
Select a preset radio station
1
Press / to select a preset number.
Tip
Position the antenna as far as possible from •
TV, VCR or other radiation source.
For optimal reception, fully extend and adjust
•
the position of the antenna.
Set RDS clock
You can use time signal broadcast together with
the RDS signal to set the clock of the apparatus
automatically.
1 Tune to a RDS radio station that
transmits time signals.
The apparatus reads the RDS time and »
sets the clock automatically.
Note
The accuracy of the transmitted time depends •
on the RDS station that transmits the time
signal.
English
EN
To Next Page
Loading...
