Philips MCD909 - EasyLink Features; Audio setup

25
Note
See the explanations of the above options in •
the following pages.
[HDMI Audio]
When you connect this apparatus and TV
with an HDMI cable, select the audio output
setting for this connection.
• [On] – the sound is output through
both your TV and this apparatus. If
the audio format on the disc is not
supported, it is downmixed to two-
channel sound (Linear-PCM).
• [Off] – disable audio output from
the TV. The sound is only output
through this apparatus.
[Night Mode]
Make loud sound level softer and soft sound
level louder so that you can watch the DVD
movies at a low volume, without disturbing
others.
• [Off] – enjoy surround sound with
its full dynamic range.
• [On] – enjoy quiet viewing at night
(DVDs only).
Video setup
1
Press SYSTEM.
2 Press to select [Video Setup], and then
press
.
3 Select an option and then press OK.
4 Select a setting and then press OK.
To return to the previous menu, •
press
.
To exit the menu, press • SYSTEM.
Note
See the explanations of the above options in •
the following pages.
Note
Philips does not guarantee 100% •
interoperability with all HDMI CEC devices.
[EasyLink]
• [Auto Wakeup TV] - Turn on or off
one touch play.
• [System Standby] - Turn on or off
one touch power-off. You can use
the remote control of this apparatus
to turn the apparatus and all
connected HDMI devices to standby
mode.
• [System Audio Control] - Turn on
or off one touch audio control.
[Screen Saver]
The screen saver protects the TV screen
damage due to prolonged exposure to a static
image.
• [On] – Enable the screen saver.
• [Off] – Disable the screen saver.
[DivX(R) VOD Code]
Display the DivX® registration code.
Tip
Enter this DivX registration code when you •
rent or purchase video from www.divx.com/
vod. The DivX videos rented or purchased
through the DivX® VOD (Video On
Demand) service can be played only on the
device to which it is registered.
Audio setup
1
Press SYSTEM.
2 Press to select [Audio Setup], and then
press
.
3 Select an option and then press OK.
4 Select a setting and then press OK.
To return to the previous menu, •
press
.
To exit the menu, press • SYSTEM.
English
EN