11EN
3 Insert the black wire into the black (-)
socket.
4
main unit marked 'LEFT'.
5 Repeat steps 2-3.
Connect power
Caution
Risk of product damage! Make sure that the power
supply voltage corresponds to the voltage printed on
the back of the unit.
Before connecting the AC power cord, make sure that
you have completed all other connections.
1 Connect the AC power cord to the power
outlet.
Prepare the remote control
Caution
Risk of explosion! Keep batteries away from heat,
To insert the remote control battery:
1 Open the battery compartment.
2 Insert 2 AAA batteries (not supplied) with
correct polarity (+/-) as indicated.
3 Close the battery compartment.
Note
If you are not going to use the remote control for a
long time, remove the batteries.
Do not use old and new or different types of batteries
in combination.
Batteries contain chemical substances, so they should
be disposed of properly.
Set clock
1 Press STANDBY-ON to switch the unit
to standby.
» --:-- (or clock) is displayed.
2 Press and hold CLOCK/DISPLAY to
activate the clock setting mode.
» The 12 hour or 24 hour format is
displayed.
3
1
2
To Next Page
Loading...
