16 EN
8 Other features
Set the alarm timer
This unit can be used as an alarm clock. The disc
or tuner is activated to play at a preset time.
1 Make sure that you have set the clock
correctly.
2 Press POWER to switch the unit to
standby.
» The clock is displayed.
3 Press and hold TIMER.
» A prompt to select the source is
displayed.
4 Press DISC, TUN, or TAPE to select a
source.
5 Press TIMER
» The hour digits are displayed and begin
to blink.
6 Press / (or TUNING / on
the remote control) to set the hour.
7 Press TIMER
» The minute digits are displayed and
begin to blink.
8 Press / (or TUNING / on
the remote control) to set the minute.
9 Press TIMER
» The timer is set and activated.
Activate and deactivate alarm timer
1 Press TIMER ON/OFF repeatedly to
activate or deactivate timer.
» If timer is activated, the display shows
.
» If timer is deactivated,
disappears.
Note
Alarm timer is not available in AUX mode.
If disc or tape source is selected and the track or tape
cannot be played, tuner is activated automatically.
Set the sleep timer
This unit can switch to standby automatically
after a set period of time.
1 When the unit is turned on, press SLEEP
repeatedly to select a set period of time
(in minutes).
» When sleep timer is activated, the
display shows
.
To deactivate sleep timer
1 Press SLEEP repeatedly until "0" is
displayed.
» When sleep timer is deactivated,
disappears.
Listen to an external device
You can listen to an external audio device (such
as an MP3 player) through this unit.
1 Press AUX to select AUX source.
2 Connect an audio cable (not supplied) to:
AUX jack (3.5 mm) on the unit
the headphone jack on an external
device
3 Start to play the device (see the device's
user manual).
To Next Page
Loading...
