& Reduce the distance between the remote
control and the unit.
& Insert the battery with its polarities (+/–
signs) aligned as indicated.
& Replace the battery.
& Aim the remote control directly at the
sensor on the front of the unit.
No disc detected
& Insert a disc.
& Check if the disc is inserted upside down.
& Wait until the moisture condensation at
the lens has cleared.
& Replace or clean the disc.
&
Poor radio reception
& Increase the distance between the unit and
your TV or VCR.
& Fully extend the antenna.
Timer does not work
& Set the clock correctly.
& Switch on the timer.
Clock/timer setting erased
& Power has been interrupted or the power
cord has been disconnected.
& Reset the clock/timer.
To Next Page
Loading...
