Philips R7705 - Storing FM Radio Stations Manually

7
EN
Store FM radio stations manually
Note
• You can store a maximum of 20 FM radio stations.
1 Tune to an FM radio station.
2 Press and hold PRESET for more than 2
seconds to activate programming mode.
3 Press TUN repeatedly to select a number.
4 Press PRESET again to conrm.
5 Repeat steps 1 to 4 to store more FM
radio stations.
Tip
• To remove a pre-stored station, store another station
in its place.
Select a preset radio station
1 In FM tuner mode, press PRESET.
2 Press TUN repeatedly to select a
preset radio station, then press SELECT to
conrm.
Show RDS information
RDS (Radio Data System) is a service that
allows FM radio stations to show additional
information.
While listening, press MENU / INFO repeatedly
to scroll through the following information (if
available):
• Station frequency
• Station name
• Program name
Use FM menu
1 In FM tuner mode, press and hold MENU /
INFO for more than 2 seconds to access the
FM menu.
2 Press TUN to scroll through the
menu options:
• [Audio]: select Stereo or Mono.
• [Scan]: scan settings.
• [System]: adjust system settings.
3 To select an option, press SELECT.
4 Repeat steps 2-3 if any sub-option is
available under an option.
[Scan] (scan setting)
• [All] (all stations): scan all the available FM
radio stations.
• [Strong] (strong stations only): scan FM radio
stations with strong signals only.
[System]
• [Reset]: reset all the settings to factory default.
• [SW Version]: know the software version of
the unit.
• [Language]: set system language (English
/ Deutsch / Itliano / Français / Norsk /
Nederlands).