English
Using the SmartClean system
Caution: Always shake excess water o the
shaver before you place it in the SmartClean
system.
1 Press the top cap to be able to place the shaver
in the holder ('click').
2 Hold the shaver upside down above the holder.
Make sure the front of the shaver points
towards the SmartClean system.
3 Place the shaver in the holder (1), tilt the shaver
backwards (2) and press down the top cap to
connect the shaver ('click') (3).
The battery symbol starts to ash, which
indicates that the shaver is charging.
4 Press the on/o button on the SmartClean
system to start the cleaning program.
During the rinsing phase, the rinsing symbol
ashes. When the rinsing phase is done (after
approx. 10 minutes), the rinsing symbol goes out.
1
2
3
50
To Next Page
Loading...
