Philips S9731 - Replacing the Cartridge of the Smartclean System

English
After the rinsing phase, the drying phase starts
automatically. During this phase, the drying
symbol ashes. When the drying phase is done
(after approx. 4 hours), the drying symbol
goes out.
When the cleaning program is done, the ready
symbol lights up continuously.
30 minutes after the cleaning program and
charging are done, the SmartClean system
switches o automatically.
The battery symbol lights up continuously to
indicate that the shaver is fully charged. Charging
takes approx. 1 hour.
Note: If you press the on/o button of the
SmartClean system during the cleaning program,
the program aborts. In this case, the rinsing or
drying symbol goes out.
Note: If you remove the supply unit from the wall
socket during the cleaning program, the program
aborts.
Replacing the cartridge of the SmartClean system
Replace the cleaning cartridge when the
replacement symbol ashes orange or when you
are no longer satised with the cleaning result. If
you clean the shaver in the SmartClean system
once a week, the SmartClean cartridge lasts
approximately three months.
1 Press the button on the side of the SmartClean
system (1) and lift the top part of the
SmartClean system (2).
2
1
51